Wicked lasers S3 Arctic Series Manual de usuario descargar pdf (Pagina 8)

User’s Manual & Laser Safety Guide | 9

S3 Arctic Series | 8

WWW.WICKEDLASERS.COM

Using Your Laser : The SmartSwitchUsing Your Laser : The SmartSwitch

To switch to high-power mode, you may

hold the SmartSwitch button until the 3rd

LED lights up.

Holding the button again from this mode

will cycle through medium and low power

modes.

From any mode, 1 quick click will put the

laser into tactical standby mode. The 3 LED

lights will start ashing to show the laser is

on stand-by.

A double click will set the laser to strobe

mode. Another double click will exit this

mode.

To set the laser to full-power / momentary

mode, hold the SmartSwitch + press the

tailcap button. After unlocking the laser, the

3 LEDs will be lit up.

The laser will now only work whenever the

SmartSwitch is pressed. To exit this mode, turn

o󰮏 the laser by pressing the tailcap button.

SmartSwitch™ Codes Recap:

▪ Unlocking code - 3 quick clicks + 2 short holds will turn on the laser.

▪ Low, Medium, High power mode - Pressing and holding the SmartSwitch will cycle through the power

modes. 1 LED light indicates low power mode, 2 LEDs for medium power and 3 LEDs for high-power.

▪ Tactical Standby Mode - 1 quick click will set the laser to standby mode and another quick click will

turn it back on.

▪ Strobe Mode - Double clicking the SmartSwitch button will set the laser to strobe mode. To exit, just

double click on the button again.

▪ Full-power / Momentary Mode - Hold the SmartSwitch and press the button on the tailcap then

proceed with unlocking the laser. The laser will only operate while the SmartSwitch button is pressed.

The laser must be turned o󰮏 to exit this mode.

FLASHING

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 16 17

Sin comentarios

Wicked lasers S3 Arctic Series Manual de usuario Pagina 8